ioLogik Cellular Micro RTU Controller Getting Started
ATTENTION
When connecting the I/O device to the ioLogik’s dry contacts, we strongly recommended connecting DI.Com
to the power of the external sensor to avoid affecting other channels.
DI.Com input power should be limited
at
12 to 36 VDC.
ATTENTION
Sensor types are arranged in groups, with DI
O-0 to DIO-3 forming one group and DIO-4 to DIO-7 forming
another group. If an NPN sensor is connected to DI
-
0, then only NPN sensors can be connected to the other
DI channels in that group (i.e., DI
O-1, DIO-2, and DIO-3). Likewise, if a PNP sensor is connected to DIO-4
,
then only PNP sensors can be conn
ected to the other DI channels in that group (i.e., DIO-5, DIO-6, and
O-7).
Testing the I/O Device
Power on the ioLogik W5300, try changing the I/O status, and then use ioAdmin to determine if the status has
changed under the I/O Configuration bar. (Refer to the figure below)
Comments to this Manuals