Moxa IOLOGIK E4200 User Manual download pdf (Page 23)

ioLogik Active Ethernet I/O Family User’s Manual Initial Setup

2-9

Connecting to the Network

ioLogik E4200 Active Ethernet Network Adaptor

The ioLogik E4200 Active Ethernet network adaptor supports standard 10/100 Mbps Ethernet. For

first time users, we recommend that you link from your host computer to the ioLogik E4200 over a

local Ethernet network to take care of IP and system configuration. Once the installation is done,

you may move the whole I/O system to the field. Note that you can insert any LAN port to make

the configuration setting work.

1. Connect the ioLogik E4200 to the host PC with an Ethernet cable. For initial setup of the

ioLogik E4200, it is recommended that the ioLogik E4200 be configured using a direct

connection to a host computer rather than remotely over the network.

Note: While you configuration, please make sure only one connection exist. Don’t use

two connections to connect ioLogik E4200, or some unexpected error will happened.

2. If you connect to the host PC by LAN 0, configure the host PC’s IP address to

192.168.127.xxx. (xxx: from 001 to 253). In Windows, you will need to do this through the

Control Panel. If you connect to the host PC by LAN 1, configure the host PC’s IP address to

192.168.126.xxx. (xxx: from 001 to 253). In Windows, you will need to do this through the

Control Panel.

LAN Port Default IP Address Default Netmask Default Gateway

LAN 0 192.168.127.254 255.255.255.0 None

LAN 1 192.168.126.254 255.255.255.0 None

3. Use Modular ioAdmin or the web console to detect the ioLogik E4200. Once the ioLogik

E4200 has been detected, modify the settings as needed for your network environment, then

restart the I/O.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 104 105

No comments

Moxa IOLOGIK E4200 User Manual Page 23