Moxa EDR-810 User Manual download pdf (Page 88)

Industrial Secure Router User's Manual Network Redundancy

6-2

Layer 2 Redundant Protocols (EDR-810 series

only)

Configuring STP/RSTP

The following figures indicate which Spanning Tree Protocol parameters can be configured. A more detailed

explanation of each parameter follows.

At the top of this page, the user can check the Current Status of this function. For RSTP, you will see:

Now Active:

It shows which communication protocol is being used—Turbo Ring, RSTP, or neither.

Root/Not Root

This field only appears when RSTP mode is selected. The field indicates whether or not this switch is the Root

of the Spanning Tree (the root is determined automatically).

At the bottom of this page, the user can configure the Settings of this function. For RSTP, you can configure:

Redundancy Protocol

Setting Description Factory Default

Turbo Ring Select this item to change to the Turbo Ring configuration page.

None

RSTP (IEEE

802.1W/1D)

Select this item to change to the RSTP configuration page. None

Bridge priority

Setting Description Factory Default

Numerical value

selected by user

Increase this device’s bridge priority by selecting a lower

number. A device with a higher bridge priority has a greater

chance of being established as the root of the Spanning Tree

topology.

32768

Forwarding Delay (sec.)

Setting Description Factory Default

Numerical value input

by user

The amount of time this device waits before checking to see if it

should change to a different state.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 128 129

No comments

Moxa EDR-810 User Manual Page 88