Moxa ONCELL G2110-T User Manual download pdf (Page 63)

OnCell G2100 Series User’s Manual AT Command Set

4-5

AT Command Examples

The following examples can give users a better understanding of how to use the AT Commands.

ATTENTION

Make sure that the RS-232 port of the OnCell G2100 Series modem is connected. For the OnCell

G2150I, make sure DIP switch 1 is set to ON.

Modem Acknowledgement

Connect the RS-232 port of the OnCell G2100 Series modem to a host PC. Start PComm Terminal

Emulator with the current communication parameters (default: 115200 bps, 8 data bits, None parity,

1 stop bits, and no flow control). Type AT and press Enter. A modem response of OK indicates

that the modem is ready.

Verify Signal Strength

Connect the RS-232 port of the OnCell G2100 Series modem to a host PC. Open PComm Terminal

Emulator with the current communication parameters (default: 115200 bps, 8 data bits, None

parity, 1 stop bits, and no flow control). Type AT+CSQ and press Enter. The modem will

respond with the receive signal strength (RSSI) and channel bit error rate (BER).

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 104 105

No comments

Moxa ONCELL G2110-T User Manual Page 63