Moxa NPORT 5610-16 User Manual download pdf (Page 89)

NPort 5600 Series User’s Manual Configuring NPort Administrator

6-20

Port Monitor

1. The process described here is the same as in the previous “Monitor” section. The only

difference is that you can select more items under Port Monitor than under Monitor.

2. Select or de-select Monitor Items. Use the single arrowhead buttons to move highlighted items

from one box to the other. Use the double arrowhead buttons to move all items from one box

to the other.

COM Mapping

NPort Administration Suite comes with Windows 95/98/ME/NT/2000/XP Real COM drivers.

After you install Windows Administration Suite, there are two ways to set up the NPort’s serial

port as your host’s remote COM port. The first way is with On-line COM Mapping. On-line

COM Mapping will check to make sure the NPort is connected correctly to the network and then

install the driver on the host computer.

The second way is with Off-line COM Installation, without connecting the NPort to the network

first. Off-line COM Mapping can decrease the system integrator’s effort by solving different field

problems. Via off-line installation, the user can process the host software installation and then

install the NPort to different fields.

Use the following procedure to map COM ports:

1. On-line COM Mapping:

Connect NPort to the network Æ Set NPort to the proper IP address Æ Map COMs to your

host Æ Apply Change.

2. Off-line COM Mapping:

Map COMs to your host Æ Apply Change Æ Connect NPort to the network Æ Configure

NPort’s IP address.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 115 116

No comments

Moxa NPORT 5610-16 User Manual Page 89