- 6 -
ATTENTION
This is a Class 1 Laser/LED product. Do not stare into the
Laser Beam.
Switch Settings
There are 2 sets of DIP switches on the board. One set for fiber and another for
the connector. Following are the settings for the 4 connector DIP switches.
ON
Serial Connection Switch 1 Switch 2
RS-232 ON (default) ON (default)
RS-422 ON OFF
2-wire RS-485 OFF ON
4-wire RS-485 OFF OFF
120Ω Terminator Switch 3
Enable ON
Disable OFF (default)
Fiber Mode Switch 4
Ring Mode ON
Point to Point Mode OFF (default)
Comments to this Manuals