Moxa TCF-142-S-ST-RM Installation Guide download pdf (Page 3)

- 3 -

Installation

The media converter slide-in module can be hot-swapped, which means the

chassis doesn’t have to power off or be removed during installation. Align the

slide-in module with the chassis installation slot so that the panel fastener

screw is at the top of the module. Carefully slide the slide-in module into the

slot while aligning the module’s circuit board with the installation guide.

Ensure the slide-in module is firmly seated inside the chassis. Push in and

rotate the attached panel fastener screw clockwise to secure the module to the

chassis.

Features

y “Ring” or “Point to Point” transmission

y Extend RS-232/422/485 transmission distance:

¾ up to 40 km with single-mode—TCF-142-S-XX-RM slide-in modules

series

¾ up to 5 km with multi-mode—TCF-142-M-XX-RM slide-in modules

series

y Slide-in modules of NRack system

y Decrease signal interference

y Protect against electrical degradation and chemical corrosion

y Support baudrate up to 921.6 Kbps

Package Checklist

Before installing the TCF-142-RM slide-in module, verify that the package

contains the following items:

y TCF-142-RM slide-in module Fiber Converter

y Quick Installation Guide

y Warranty Card

NOTE: Please notify your sales representative if any of the above items are

missing or damaged.

1 2 3 4 5 6 7 8 9

No comments

Moxa TCF-142-S-ST-RM Installation Guide Page 3