Moxa INJ-24A Installation Guide download pdf (Page 6)

- 6 -

DIN-Rail Mounting

The DIN rail attachment plate should already be fixed to the back panel of

INJ-24A when you take it out of the box. If you need to reattach the DIN

Rail attachment plate, make sure the stiff metal spring is situated towards

the top, as shown in the figures below.

STEP 1:

Insert the top of the DIN

ail into the

slot just below the stiff metal spring.

STEP 2:

The DIN r

ail attachment unit will

snap into place as shown below.

To remove the INJ-24A from the DIN rail, simply reverse steps 1 and 2

above

Wall Mounting (optional)

For some applications, you will find it convenient to mount the INJ-24A on

the wall, as shown in the following figures.

STEP 1: Remove the aluminum

DIN rail attachment plate from the

INJ

-24A’s rear panel, and then

attach the wall mount plates as

shown in the diagram to the right.

STEP 2: Mounting the INJ-24A on the wall requires 4

screws. Use the switch, with wall mount plates

attached, as a guide to mark the correct locations of

the 4 screws. The heads of the screws should be less

than 6.0 mm in diameter, and the shafts should be

less than 3.5 mm in diameter, as shown in the figure

at the right.

NOTE

Before tightening the screws into the wall, make sure the screw

head and shank size are suitable by inserting the screw into one

of the keyhole

shaped apertures of the wall mounting plates. Do

not tighten

the screws completely—leave about 2 mm to allow

room for sliding the wall mount panel between the wall and the

screws.

1 2 3 4 5 6 7 8 9 10

No comments

Moxa INJ-24A Installation Guide Page 6